HIGHSIDER AKRON-RS PRO license plate holder SUZUKI SV650

HIGHSIDER AKRON-RS PRO adjustable license plate holder KAWASAKI Z800 13-16 The HIGHSIDER AKRON-RS license plate holder adapts perfectly to the lines of your motorcycle thanks to its design. The model-specific bracket of the AKRON-RS allows mounting on the original mounting points of your motorcycle and thus a replacement without further drilling or cutting. To prevent damage to the cables, all bushings with sharp edges are protected by a rubber membrane grommet. The sign is made of 2 mm thick sheet steel. The precise cut is done by laser. After the edging, the black weatherproof powder coating still follows. This ensures optimal fit and durability. Through the stepless adjustment it is possible to bring the plate without drilling to the desired position. An additional locking screw is provided to hold the plate in this position. The AKRON-RS turn signal holders are adjustable in width and therefore suitable for any type of accessory turn signal. This adjustment option makes it possible to adapt the position of the direction indicators to the most diverse number plates. To allow the direction indicators to be mounted without separation from the wiring, the 8 mm holes are slotted laterally. The position of the reflector can also be adjusted individually via a slider. The adaptation to the different EU license plate designs is therefore no problem. To screw the license plate tightly and reduce vibrations, two rubber washers are included. Another rubber pad supports the license plate on the underside. Details: - model-specific bracket - Infinitely adjustable turn signal holder - Slotted turn signal holder for easy installation without cable separation - Infinitely adjustable reflector, E-approved - Suitable for European license plates - Adjustable angle of inclination all around 'infinity - additional screw for optimal positional security - easy fastening without further work steps (e.g. drilling) - easy license plate mounting via slotted holes Included with AKRON-RS PRO: - Model-specific bracket with mounting parts - Door AKRON-RS license plate - Adjustable turn signal holder - E-approved reflector with adjustable holder - E-homologated license plate light - Assembly instructions Notes: - For the original turn signals, a special turn signal holder is optionally available in the accessories sheet. - If the side reflectors are mounted on your original license plate holder, these must be reattached in a suitable position or replaced with new ones. Advice: If you have not found a specific license plate holder for your vehicle, the universal license plate holders from HIGHSIDER, which are available in many different designs, are certainly a good alternative. Accessory compatible with the following models: Suzuki SV 650 (A2) - 35 KW CX273C 2021 2021 Suzuki SV 650 (A2) - 35 KW CX273C 2022 2022 Suzuki SV 650 - 56 KW WCX0/CX1236 2016 2016 Suzuki SV 650 - 56 KW WCX0/ CX1236 2017 2017 SUZUKI SV 650 - 56 KW WCX0/CX1236 2018 2018 Suzuki SV 650 - 56 KW WCX0/CX123C 2019 SUZUKI SV 650 - 56 KW 2020 2020 Suzuki SV 650 - 56 KW CX163C 2021 2021 Suzuki SV 650 - 56 KW163B 2022 2022