HIGHSIDER CLASSIC CNC button, suitable for 7/8 and 1 inch handlebars CNC milled switch with two buttons. Universally applicable for controlling load relays, switching various modes on speedometer, etc. Connections: Button A: green and red (from below) Button B: green and brown Green is the input signal Dimensions: Button Ø: 4.5 mm Rubber: 75 mm x 0.3 mm Anbus screws: M3x 5 mm Length 570 mm cable Delivery: 1x button 1x rubber 2x screws Note: NOT for currents greater than 0.05 amps. So at 12 Volt max. 0.6 Watt.