Electronic box AXEL JOOST version G, 12V with handlebar adapter

The G-Box is an electronic box with handlebar adapter that controls the main electrical functions with the motorcycle's buttons from a central position. The Electronicbox offers the following functions: - Light control with switch and button - Light control - Flasher control - Emergency flash function - 2 times flashes when the ignition is on - Flasher function with automatic switch-off - Horn control - Start relay control - Engine stop function control - Alarm switch input - Brake light control - Neutral control - and standby switch. - 8 status LEDs on the cable side for quick and easy wiring control. ebox_h_shema The supplied adapter installed on the handlebar can be connected via a single thin cable. 8 status LEDs, connected to the outputs allow easy installation and control. Most of the functions can be modified without any problems by the user. Hold down the horn button while turning on the 12V and the box is in programming mode after releasing the button. A short flash will indicate this status. You can change the function by pressing the left or right indicator button. The next programming mode is switched with an additional press on the handset button. The indicators will appear twice to show you the status. The following options are possible: Most functions can be easily changed by the user. Press and hold the horn button while turning on the 12V and the box is in programming mode after releasing the button. A short flash will indicate this status. You can change the function by pressing the left or right indicator button. The indicators will flash twice to show you the new program option. The following options are possible: - Flashing - Modus - Left button - Right button - Description 1 x Showflasher Off On 2 x Flashing at power on 2 x Comfortflasher Off On Indicators turn off after 20 x 3 x Unit Off Indicator On Indicators with 20% brightness in off mode 4 x Breake Light Off On Brake light with 50% brightness in off mode 5 x Start / Stop buttons 1 Button 2 Button 1 or 2 Start / stop button 6 x Stand / Neutral. Off on side stand and neutral switch active The functions are written in E-Eprom and can be changed each time. Please note that you must turn off the box for at least 3 seconds to discharge the internal capacitors before you can change the settings again. Dimensions: box 50 mm x 42 mm x 12 mm, adapter 35 mm x 15 mm Body material: polycarbonate, water resistant with epoxy resin Case colour: black Connections: 0.5 qmm per input, 1 qmm per power Power consumption in operation: 20 mA due to implemented LED Maximum temperature: 120 degrees Celsius Input voltage range: 6 - 13.8 Volts, temporary up to 20 Volts Maximum current of the 12V power connector: 20 Amps