AXEL JOOST Vari Load Equalizer, 12V

The scenario is well known: you have the beautiful new LED indicators installed in your bike and since then the flashing speed is no longer correct, or the ECU emits error messages because the flashing relay or the control unit with the lower power of the new indicators can not handle or think that your turn signal is broken. Now you can order several load equalizers on the aftermarket, pay it and test it on your bike until you find the right value... This is the solution: the adjustable digital equalizer with 50 selectable power values. The Vari Load is simply attached to the direction indicators and the necessary load is simply set via the blue "programming cable". The power of the Vari Load is changed by the thin blue cable. Simply hold the blue cable against +12 volts and the load will slowly increase in 50 steps to about 10 watts. Holding the blue cable against the ground reduces the load by up to 0 watts. Once the cable is disconnected from the ground or +12 volts, the set charging value will be saved and recalled the next time you turn on the power. A full stroke of all recoverable power values takes approximately 20 seconds. The built-in LED then flashes up to 50 times when the power value changes and indirectly indicates the set value for the number of flashing lights. As soon as one of the two limits (0 watt or approx. 10 watt) is reached, it lights up permanently. Characteristics: Dimensions: 56 mm x 36 mm x 17 mm without fixing straps Body: black ABS, cast with 2-component composite putty Input voltage: 8 - 15 volts Connections: program cable 0.14 mm², power section 0.75 mm² Installable load range: between approx. 2 x 1 watt and 2 x 10 watt in approx. 0.2 watt increments Maximum ambient temperature: 90 degrees Celsius