MOTOGADGET M-Flash intermittent relay

The M-Flash model is the most compact load-independent flashing relay on the market. Nothing comes close for size and simplicity! The m-Flash flashing unit replaces all relays of conventional flashers. All the advantages summarised: - ultra-compact and lightweight - basically just a piece of cable connected to a small device the size of a candy - ideal for custom bikes with little mounting space - the bulky relays or load resistors are a thing of the past - the wiring can be inserted into the bar or frame tube or wiring - almost independent of the load (at least 1 Watt) - Fully implemented using digital semiconductor technology. Microprocessor controlled No mechanical operation, no coil, no electrical contact - Constant and correct flashing frequency and suitable for almost all LED indicator lights, all micro and indicator lights and all 10 watt and 21 watt direction indicators - e. g. works with 4 direction indicators or 2 direction indicators with bar handle - Immediate illumination without leakage and clearer than all direction indicator lights - Simple connection thanks to just two cables: simply connect them in series - completely watertight and vibration-resistant thanks to the short-circuit-proof moulded construction, automatic overload protection, power supply up to 100 W. - no heat generation during operation - Only an operating voltage of 5 - 18 V is required - therefore applicable for 6 V direction lights - "made in Germany" quality - from motogadget Dimensions: Housing (W x D x H): 18 mm x 13 mm x 9.5 mm Connector cable length: approx. 2 x 50 mm Weight: approx. 4 g Notes a) The m-Flash replaces a conventional flashing relay. This flashing relay is usually implemented BEFORE the indicator switch. The most convenient way to mount the m-Flash is simply to search for and replace the original relay. b) The m-Flash cannot replace the push-button controls of a push-button instrument. Please refer to our + relay (code 204362) if you are looking for a flashing relay for push buttons. c) The new Harley-Davidson series of models uses a special module to control the flasher controls (TSM / TSSM). These modules cannot be replaced or completed by m-Flash. Content of shipment: 1 piece Attention: If you are looking for a flashing relay with automatic deactivation, please refer to our m-Stop series!