CAN-BUS HIGHSIDER CBW1 resistance 1 piece

CAN BUS resistance from HIGHSIDER CBW1 with DIP-switch. The newly developed HIGHSIDER CAN-BUS resistor CBW1 fits most vehicles equipped with a CAN-BUS system. The CBW1 resistor provides the necessary electrical load for your vehicle, which, if the dip switches are set correctly, will not cause the accessory flashers in the cockpit to flash. Reliability is also provided. This means: If the accessory indicators fail due to an electronic fault, an error message is immediately displayed in the cockpit. Up to 2 channels can be operated, e.g. direction indicators at the rear left and direction indicators at the rear right. The CBW1 can also be used on vehicles equipped with original LED indicators. The following resistance values can be set: 150 ohms 170 ohms 240 ohms 300 ohms 400 ohms 600 ohms 1200 ohms Dimensions: Height = 11mm Width = 31mm (without straps) Width = 46mm (with tabs) Length = 40mm Cable length = 200mm with pins Connections: Yellow = input channel 1 (+) Orange = output channel 1 (+) Blue = input channel 2 (+) Red = output channel 2 (+) Grey = input ground (-) Black = output surface (-) Delivery volume: 1 piece